Prusaslicer for the Anycubic Kobra Go
Prusaslicer is a great alternative to Cura especially for advanced users. The only downside is that there is no profile for the printer like in Cura.
During setup, I used the Anycubic Mega Zero because its hardware is similar to the one used in the Kobra Go. There are only a couple of parameters you need to change. First of all, you have to change the firmware. You can find this in the printer settings. By default, the Gcode type is Marlin (legacy) which you need to change to Marlin 2. The shape and size of the bed of the Kobra Go is similar to the one of the Mega Zero (the only difference is 2mm). Now you only have to change the material parameters to your likings and you have the printer all set up.
For more information on Prusaslicer settings for the Anycubic Kobra Go, check out this Reddit thread.